1. Immediately after observing the slow flashing of the remote control, press and hold a button on the original remote control until the universal remote control light flashes quickly.
   

1. Press the button on the universal remote control you want to use.
   

Step 2: Programming the remote control on automation

Avidsen portal engine

Card AVLO

1. Press "-", L1 lights up.
   
2. Press OK, L1 and L4 light up alternately.
   
3. Within 10 seconds, press theRemote control button to remember.
   
4. If all red LEDs light up for 1Second = the memorization went well.
   
5. If the red LEDs all light up by flashing3 times = the system exceeded 10 secondsWaiting without receiving anythingValid, start programming again.
   

CAME portal engine

1. Open the caseof the receiver. It is usually close to your engine.
   
2. Once your receiver is open, spot the programming button
   
3. Press the button on your universal remote control and the buttonof your receiver
   
4. Release the buttons.
   
5. Your remote control is programmed.
   

Portal engine SOMFY

1. Press and hold the "POWER" button on the electronic box for 2 seconds. The Power light comes on.
   
2. Place the universal remote control on the target present on the electronic enclosure.
   
3. Press briefly press (<0.5s) button on the remote control that will drive the opening/closing of the engine. The RADIO light comes on during pressing and then turns off when you release the button.
   
4. The remote control is stored in total open/closure control.