Connecting a solar kit
We will see in this tutorial how to plug in a solar kit |
Avidsen - 114375 - Universal solar kit for gate motorization
Before Proposal
The solar kit uses two 7Ah 12V lead-acid batteries.
Before using the engine for the first time, let the batteries charge for at least 24 hours.
Pay close attention to connections. Respect polarity in all circumstances at the risk of damaging the appliance.
Be careful to avoid short circuits. Insolate the wires well when connecting.
Step 1: Connecting the panel
Plug two wires into the panel. Locate the + and - threads.
Then plug the solar panel into the MPPT board into the solar kit box respecting the polarity.
Connection of batteries
Be careful, plug in the batteries according to the supply voltage of your engine.
If it is a 12V engine, the batteries must be plugged in parallel.
If it is a 24V engine, the batteries must be plugged in series.
Today all our engines are in 24V.
The 12V connection applies only to older engines.
This connection will not be discussed in this tutorial.
Reminder
Cosses of parallel connection 12V opposite.
Reminder
of the 24V series connection opposite.
Step 2: Connecting to MPPT card
Once you have spotted the type of connection, plug the + and - pod wires into the MPPT card.
Step 3: Connecting the power wires
Plug two wires to the output of the MPPT board.
Plugging to a 24V CA2B9 card
For sliding engine cards, connect the two "Motor" output wires of the MPPT board to the SOL + SOL + SOL input - respecting the polarity.
Plugging into an AVLO 24V card
For 24V leaf gate engines, the supplied connector must be usedwith the engine.
It is in a craft bag.
Use a domino to connect the MPPT board output cables of the MPPT board and the connector.
Caution: Do not use the transformer's 230V terminal block to make the connection.
Step 4: Connecting batteries
Then connect the pods to the batteries.
It is possible when closing the circuit, when connecting the last pod, that a spark appears at the pod. This is a normal phenomenon.
Related Articles
114376 - Resolution failure at start-up Solar kit
In case of non-operating the solar kit or if the voltage measured at its output is between 5 and 7V, it is necessary to check a connection. Please see the tutorial below. Difficulty: Easy Time required: 10 minutes Number of steps: 5 Updated: June ...How to perform electrical measurements on solar kit 114375
In this tutorial, we will discuss the measuring points to be performed in order to check the proper functioning of the solar kit Avidsen 114375 This tutorial is applicable to: Avidsen - 114375 - Universal solar kit for gate engine Difficulty: Good ...