ORANE 410 transmission shaft replacement
Follow this step-by-step tutorial to replace the transmission axis of an ORANE 410 engine |
Avidsen Articulated Bras 114200-114201-114202-114302-114203-510062
Difficulty: Moderate Time required: 20 minutes Number of steps: 10 Updated: October 2025 | Equipment required: Key or head BTR 4, Large flat screwdriver Detached part(s): Reference: 580227H |
Step 1: Identify BTR screws
Locate the 7 BTR screws (starred in red).
Tip: Bring unscrewing
Factory, the screws can be tight and cannot be turned with a screwdriver. Using a BTR key, unscrew the screws to cut them off. Once the screw can be turned freely, you can use the screwdriver to go faster.
Step 2: Unscrew BTR screws
Remove the 7 BTR screws from the engine.
Step 3: Open the engine
Once the last screw is removed, the engine will open on its own, the engine axis rising due to its rest on the worktop.
Step 4: Extract the engine
Take out the electric motor and motor shaft (which can sometimes remain attached to the motor support).
Step 5: Remove the transmission axis
Lift the transmission axis by its large bearing.
Step 6: Remove the transmission axis
Then get a flat screwdriver and lever to extract the rear part of the transmission axis.
The transmission axis has come out.
Step 7: Remitting the new transmission axis
Move the engine base to the edge of the worktop so that its arm axis outlet hole is in a vacuum. Put the new transmission axis back into the engine.
Attention!
Think about grease with rolling grease or with excess grease in the engine the new transmission axis.
Step 8: Remind the arm axis
Reposition the arm axis in the motor base.
Step 9: Remitting the electric motor
Reposition the electric motor above the engine base.
Attention!
Check that there is no more space between the engine bracket and the engine base.
Step 10: Engine closure
Turn the 7 BTR screws on the engine