Programming of remote controls on an AVLO card- Partial opening
We will see in this tutorial how to program remote controls for partial opening (1 beat) on AVLO electronic card |
During the first installation of the engine, it will be necessary to program the remote controls on the electronic card of the motorization.(For remote controls to work the self-learning must have been performed).
Make sure that at the end of self-learning, the portal is closed.
Step 1: Radio listening to the map
Press the " -" button on the electronic card. The L1 light lights up in red.
Press the "+" button on the map once. The L2 light turns on in red.
Press the "OK" button on the electronic card once. The lights L1 and L4 flash red.
Be careful, the card will listen to radio for 10s. After this delay, it will automatically exit the programming mode. Quickly move to step 2 so that the remote control can be programmed.
Step 2: Remote Control
Press the remote control button that you want to record for partial opening.
When pressing the remote control button, the four red lights on the card will turn on quickly and then turn off.
If the red lights on the card do not turn on, but the green LED of the card flashes, press the remote control button a second time.
The remote control is programmed.
In case of failure
If you waited more than 10s before pressing the button, or the card has not received the remote control information, the card will stop flashing its red lights L1 and L4.
It will then be necessary to start the procedure again since step 1
Full memory
The electronic card can record up to 15 remote control buttons.
If the radio memory is full, it will not be possible to add other radio elements on it.
The map has an LEDS animation informing you of this status when attempting programming.
When validating step 1 by short pressing the OK key, instead of flashing the lights L1 and L4, the card will quickly turn on all its red lights twice.
In this case, it will be necessary to remove the radio memory to obtain memory space again (see deletion tutorial of the radio memory)
Attention
Partial opening is only available with Semi-Automatic and Automatic modes. On the other hand, if you have enabled Collective mode, the partial opening function is disabled. Make sure you have selected Semi-Automatic or Automatic mode in the card settings if the partial opening order is not taken into account by the card.
In case a beet closes alone when you give a partial opening order, while your fighters are open, it means that an inversion of polarity on the connection of your beats is present. Refer to the engine connection tutorial.