Replacement electric motor OREA 500 +
You will find in this tutorial all the steps to replace an electric motor for OREA 500 + |
Difficulty: Moderate Time required: 15 minutes Number of steps: 10 Updated: October 2025 | Equipment required: Key BTR 5, Cruciform screwdriver, Flat screwdriver Detached part(s): Reference: 580145H |
Step 1: Remove card holder
Remove both fixing screws from the card/transformer holder and remove it from the engine block.
Step 2: Remove the card effect hall
Unscrew the two cruciform screws for holding Hall effect card on the electric motor
Step 3: Unscrew engine cables from terminal block
Remove the motor wires from the card terminal using a small flat screwdriver
Step 4: Remove Hall effect card
Remove Hall effect card from electric motor
Step 5: Remove motor screws
Unscrew the 4 BTR screws using a BTR key of 5.
Step 6: Extract electric motor
Lift the engine to proceed with its extraction. You can use a flat screwdriver to leverage and help you lift the engine.
Step 7: Remitting the new electric motor
Put the new electric motor by paying attention to the position of the cable output (green arrow) relative to the toothed wheel (red circle).
Step 8: Putting back the card effect hall
Reposition the hall effect hall.
Position the legs of the component upwards.
Step 9: Go up the engine
Turn over the Hall effect card, electric motor and card holder.
Step 10: Put the cables back the cables
Turn the motor wires on the terminal block.