Synchronization of the monitor and the EXTEL WAVE 2 Street
Your monitor no longer sounds when a visitor presses the call button? Your monitor requires being resynchronized to the door station.In order to limit errors due to too large obstacles, please bring the door station closer to the monitor. |
Difficulty: Easy Time required: 30 minutes Number of steps: 6 Updated: June 2024 | Equipment required: BTR 1.5mm |
Step 1: Preparation of street platinum
- Bring your door station closer to the monitor
- Position your door station to have access to the underside.
- Use the 1.5mm BTR screwdriver to screw the safety screw.
- Turn the screwdriver in the opposite direction to the needles of a watch to screw the safety screw.
- ATTENTION: The security screw uses a step on the left.
- Insert the 1.5mm BTR screwdriver into the left slot.
- Leave upwards to remove the front.
- Place the ON/OFF cursor in the ON position
Step 2: Configuration of the monitor.
- Place yourself in front of the monitor
- Make sure the monitor is properly powered by the 5V1A AC adapter
- Turn off screen, press twice
in order to enter the menu of the monitor.
- The orange icone tells you where the selection cursor is located.
- Press 4 x on
in order to move the cursor to the right.
- Press on
to enter the settings.
- Press 1 x on
in order to move the cursor down.
- Press on
to enter the association setting.
- Press 1 x on
in order to move the cursor left.
- Press on
to validate the association.
Step 3: Association of the instructor with door station
- A 60-second count will start on the monitor.
- During this countdown, hold the synchronization button on the door station for 1 second.
- The count should stop
- The count should stop immediately on the monitor
- An icon
should inform you of the right association.
- Please perform a functional test by pressing the call button on the door station to ensure proper functioning.