Street Platinum Speaker Replacement EXTEL WAVE 2

Street Platinum Speaker Replacement EXTEL WAVE 2

Remplacement du Haut-Parleur de la platine de r...

Visitors no longer hear you or the door station no longer emits sound when pressing the call button. The speaker of your door station seems failing.Before any intervention or maintenance, please turn off each element of your video doorman and place yourself on a suitable surface so as not to scratch the lens


Difficulty: Moderate
Time required: 30 minutes
Number of steps: 6
Updated: June 2024
Equipment required:
Cruciform screwdriver, BTR 1.5mm, plastic spatula, precision clamp
Detached part(s):

Step 1: Remove front panel and battery

  • Position your door station to have access to the underside.
  • Use the 1.5mm BTR screwdriver to screw the safety screw.
  • Turn the screwdriver in the opposite direction to the needles of a watch to screw the safety screw.
  • ATTENTION: The security screw uses a step on the left.
  • Insert the 1.5mm BTR screwdriver into the left slot.
  • Leave upwards to remove the front.
  • Place the ON/OFF cursor in the OFF position.
  • Extract the battery by removing it down.

Step 2: Remove the back side

  • Return the door station and using the cruciform screwdriver, remove the 6 screws at the back of the door station.

Step 3: Disassembly of electronic card

  • Gently disconnect the microphone connector by pulling it upwards using a precision clamp. Be careful, do not shoot the threads.
  • Unscrew the 4 holding screws of the door station to have access to the bottom connectors
  • Gently lift your electronic card using the plastic spatula to get it out of its home.
  • 1- Gently disconnect the speaker connector
  • 2- Gently disconnect the connector from the call button
  • 3- Gently disconnect the connector of the Infrared Leds
  • Switch the electronic card to the left to have access to the antenna.

Step 4: Replacement of the microphone

  • Using the thermal gun or a hair dryer, please heat the housing area of the microphone.
  • ATTENTION, limit the heating to 200°, there is a risk of damaging the microphone.
  • Shoot slightly on the microphone wire while heating.
  • Wait 5 minutes before handling the door station or reinstalling the new microphone.
Etape

Step

  • Make sure the microphone is the same at the same time and install the microphone in its home.
  • If the microphone does not hold in its housing, stick it with a specific non-aggressive glue (e.g. B-7000 glue).

Step 5: Electronic card disassembly

  • Temporarily reposition the electronic card on the chassis.
  • Make sure the battery connector sealing seal is properly positioned
  • Initially recognize bottom connections:
  • 1- Speaker
  • 2- Call button
  • 3- Infrared Leds

  • Make sure the antenna wire is pressed to the left of the chassis and reinstall the electronic card.
  • In order to help positioning, guide holes are present on the electronic card.
  • Make sure the ON/OFF switch on the door station is well accessible.
  • Make sure the antenna wire is always well positioned and not twisted or pinched.
  • Turn the 4 screws for holding the electronic card using the cruciform screwdriver.
  • Recognize the microphone.

Step 6: Remontage Street platinum

  • Turn the door station and using the cruciform screwdriver, turn the 6 screws to the back of the door station.
  • Replug the battery. Attention to the sense of insertion.
  • Switch the switch to the ON position.
  • Do not forget to make a reassociation between the monitor and the door station.
  • Test the correct operation on short range before final reinstallation.