EXTEL WAVE 2 Street Platinum Electronic Card Replacement

EXTEL WAVE 2 Street Platinum Electronic Card Replacement

Remplacement de la carte électronique de la pla...

The door station of your intercom no longer wants to work, no longer wants to ring? It will be necessary to replace the motherboard of your door station.Before any intervention or maintenance, please turn off each element of your video doorman and place yourself on a suitable surface so as not to scratch the lens


Difficulty: Easy
Time required: 20 minutes
Number of steps: 5
Updated: June 2024
Equipment required:
Cruciform screwdriver, BTR 1.5mm, plastic spatula, precision clamp
Detached part(s):
Reference: 820321M

Step 1: Remove front panel and battery

  • Position your door station to have access to the underside.
  • Use the 1.5mm BTR screwdriver to screw the safety screw.
  • Turn the screwdriver in the opposite direction to the needles of a watch to screw the safety screw.
  • ATTENTION: The security screw uses a step on the left.
  • Insert the 1.5mm BTR screwdriver into the left slot.
  • Leave upwards to remove the front face.
  • Place the ON/OFF cursor in the OFF position.
  • Extract the battery by removing it down.

Step 2: Remove the back side

  • Return the door station and using the cruciform screwdriver, remove the 6 screws at the back of the door station.

Step 3: Disassembly of electronic card

  • Gently disconnect the microphone connector by pulling it upwards using a precision clamp. Be careful, do not shoot the threads.
  • Unscrew the 4 holding screws of the door station to have access to the bottom connectors
  • Gently lift your electronic card using the plastic spatula to get it out of its home.
  • 1- Gently disconnect the speaker connector
  • 2- Gently disconnect the connector from the call button
  • 3- Gently disconnect the connector of the Infrared Leds
  • Switch the electronic card to the left to have access to the antenna.
Etape

Step

  • Using the cruciform screwdriver, unplug the holding tab of the antenna.
  • You can now extract the electronic card.

Step 4: Installation of the new electronic card

  • The installation of the new electronic card will be done in the opposite direction of disassembly
  • Reposition the antenna and refix it on the chassis.
  • Temporarily reposition the new electronic card on the chassis.
  • Make sure the battery connector seal is positioned well
  • Initially recognize bottom connections:
  • 1- Speaker
  • 2- Call button
  • 3- Infrared Leds

  • Make sure that the antenna wire is pressed to the left of the chassis and reinstall the electronic card.
  • In order to help positioning, guide holes are present on the electronic card.
  • Make sure the ON/OFF switch on the door station is well accessible.
  • Make sure the antenna wire is always well positioned and is not twisted or pinched.
  • Turn the 4 screws for holding the electronic card using the cruciform screwdriver.
  • Recognize the microphone.

Step 5: Remontage Street platinum

  • Turn the door station and using the cruciform screwdriver, turn the 6 screws at the back of the door station.
  • Replug the battery. Attention to the sense of insertion.
  • Switch the switch to the ON position.

  • Do not forget to make a reassociation between the instructor and the door station.
  • Test the correct operation on short range before final reinstallation.