• Initially remove the 6 cruciform screws from the powerbox hood to access the electronic card.

• Make sure the right connection of your door station with the powerbox.
• Please ensure the good condition of the connecting cable. A shortened or extended connection cable will cause a failure of the device.
• Powerbox with 15V batteries or power adapter (you do not need to powerbox by batteries and transformer at the same time).

• Press the call button on the door station.
• Street turntable should issue a ding dong, if not, please check the advice above.

Reminder: The screen is not touch, please press the sensitive buttons on the bottom of the monitor.

• Place yourself in front of the monitor
• Make sure the monitor is properly powered by the 5V1A AC adapter
• Turn off screen, press twicein order to enter the menu of the monitor.
• If the monitor does not turn on, press the ON/OFF button for 2 seconds

• The red icon tells you where the selection cursor is located.
• Press 3 x onin order to move the cursor to the right.
• Press onto enter the settings.

• Press 1 x onin order to move the cursor down.
• Press onto enter the association setting.

• Press 1 x onin order to move the cursor to the right.
• Press onto validate the association.

• A 60-second count will start on the monitor.
• During this countdown, press the call button on the door station and immediately afterwards, press the PAIR button at the bottom right of the electronic card in the Powerbox.

• The count should stop immediately on the monitor
• An iconshould inform you of the right association.
• Please perform a functional test by pressing the call button on the door station to ensure proper functioning.