• Make sure the probe and boiler module are connected together.

• Press M multiple times until manual modeappears on the screen.

• Manual mode will make it possible to operate as a conventional thermostat.
• The temperature of the thermostat is adjustable thanks to its setpoint value (SET)
• In order to increase the set temperature, please turn the adjustment knob clockwise.
• To reduce the set temperature, please turn the knob in the opposite direction to the needles of a watch.

• If the temperature probe displays the SET indication, it means that this is the set temperature. (In our example the set temperature is at 17°C)

• If the temperature probe displays youthis means that this is the temperature of the current part. (In our example the room temperature is 21°C)

Be careful, by hand handling the thermostat by hand, the temperature of the room can be greater and the values erroneous.

• If the set temperature is inferior to the room temperature, the control module will not activate and not put your heater into service.

• If the set temperature is higher than the room temperature, the control module will activate and put your heater.
• A symbolwill appear on the temperature probe.

• You can calibrate the temperature of the temperature probe as well as the hysteresis. Please refer to the advanced rule tutorial.