114376 - Start-up failure resolution Solar Kit

114376 - Start-up failure resolution Solar Kit

In case of non-operating the solar kit or if the voltage measured at its output is between 5 and 7 V, it is necessary to verify a connection. Please consult the tutorial below.

Difficulty: Easy
Time required: 10 minutes
Number of steps: 5
Updated: June 2026

Step 1: Unplug solar panel

  1. Before any intervention, please unplug the solar kit from the battery module

Step 2: Open the battery box

  1. Remove the 6 cruciform screws on the back of the solar panel for access to battery connections.

Step 3: Reconnection of the battery

  1. Locate the connector from the bottom, it matches the battery.
  2. Using a small flat screwdriver, unplug the connector from the battery by removing the black resin.



  1. Disconnect the battery connector from its stand.
  2. Wait 20 seconds.
  3. Recognize the battery connector.

Step 4: Checking the start of the solar kit.

  1. Immediately after reconnecting the battery connector, the LED light1 of the electronic card must turn on.
  2. In the case of a figure where this light does not turn on, please check that the solar panel has been disconnected before handling.

Step 5: Battery Charging

  1. Close the battery box by paying attention to positioning the white sealing seal on the cover.
  2. Recognize the solar panel thanks to its connection plug.
  3. it will be necessary to let the kit again load by the solar panel for at least 48 hours.