• Bring your door station from the monitor.
• Position your door station to have access to the underside.
• Use the cruciform screwdriver to turn the door station.
  

• Remove the door station from its wall mount.
• ATTENTION: when separating the door station from its support, do not shoot abruptlyunder risk of tearing the cable from the solar panel from the door station.

• Remove the rubber cover on the right slice of your door station.
• Switch the ON/OFF switch to ON.
• Your door station should issue a ding dong during the rocking. If this is not the case, charge the battery for 12 hours using the supplied usb-c cable.

• Place yourself in front of the inner screen.
• Make sure your monitor's blue light is on (if the light is off, please check the 5V power supply of the AC adapter).
• Black screen, press twicein order to enter the setting menu.

• The logo in blue corresponds to the selected menu.
• Press three timesin order to move the blue cursor over the setting menu.

• Press the button oncein order to enter the setting menu.

• Press once onin order to select the association menu.
• Press the button oncein order to validate the menu.

• The association menu will split into 2.
• Press once onso that the logoor in blue.

• Press once onto put your monitor in reception mode.
• A 30-second count will appear on the screen.

During the 30-second count of the monitor:

• Press the call button on the door station to wake it up, the latter should issue "ding dong"
• Pressimmediatelyon the association button for 2 seconds on the right slice of the monitor.
• The monitor's count should stop immediately (if not, make sure that the monitor and door station are close to each other).

• The monitor and door station are now associated. Please check the proper functioning.
• Press the call button on the door station, the monitor should ring a few moments later.